Make sure you are getting points.  If not, check the "not getting points" parts of the troubleshooting guide. Make sure that the Reward Sounds is checked. In the Training Control Screen click on Sound Make sure Reward Sounds is checked. If you still do not...

If you have problems running EEG Audio, try the following:   It may be that the Microsoft Forms Manager is not loaded.  This is a Windows thing that is needed to run EEG Audio.   If you use the controls from the training screen "Window / AVI Extensions, then select the EEG...

Are you receiving sound upon windows start up? Make sure your speakers are turned on and plugged into the proper jack in the sound card Click Start, Control Panel, then double click on Sounds and Audio Devices (Classic View)

The sound that is played when alpha goes above threshold (if it's a "go" or below threshold if it's a "stop") is the file "sayalpha.wav."  The corresponding theta sound is "saytheta.wav."  Both files are in c:\brainm.20. There are 8...

Solution, go to: - Control panel (classic mode) -  Sound - properties - enhancements - disable all enhancements

We re-installed Windows XP and ran the program.  We have a new problem though. We can go through the following sequence and then the problem occurs:   The following sequence is fine: Setup control menu->folder selection-> run the next session->training session screen...

In the BrainMaster Software click Sound on the menu bar and make sure Reward Sounds are selected Refer to Not Getting Points

You need to have the Microsoft forms manager installed. You run the following file to install this c:\brainm.20\Assist\fm2paste.exe  

If you are getting no sounds, and expect sounds, check the following: Are you getting points?  If your protocol should be giving you points, and you are not getting any, then the protocol conditions are note being met for some reason.  Check the thresholds to ensure you can meet the...

If you get too many sounds, or continuous sounds, check the following: If you are using manual thresholding: Adjust the thresholds until you get an appropriate amount of feedback If you are using autothresholding: Make sure autothresholding is turned on. Make sure the target percent...

Some users do not want any sound when the system detects an artifact condition. One way to eliminate artifact sound is to increase the threshold. This approach here will eliminate all artifact sounds. To silence your artifact sounds, the attached file should be saved on your PC to...

The attached file provides a "MIDI Mapper" for Vista that allows users to select their Default MIDI Playback device. It is necessary to select your MIDI Playback Device if you are having problems starting the BrainMaster software (getting a MIDI Error), or if you want to change...